Repair set for one end of gear change slide assembly, made by Burton. SEE VERY IMPORTANT NOTES

To repair both ends of slide tube you will need two kits!

Replacing the gearslide guide nylon and rubber bearing sets is a difficult job. To make this easier, Burton has developed this set so that the slide bearings can be replaced in 20 minutes.

How to: Remove the gearshift from the car. Saw the 'furled over' edge off the side that you want to replace. Remove the old guide nylon and rubber set and mount the new supplied rubber. Slide or tap the sleeve slightly over the gear lever. Secure the sleeve with a flat chisel between the markings on the sleeve. The sleeve could be glued instead.

Re-fit the gear lever to the car. This gearshift kit contains a sleeve and guide rubber for one side of the gear lever. This set can be used on the original gear lever and the stainless steel 2CV, Mehari and Burton levers. Before purchasing, check that there are no deep scratches in the gear lever. If this is the case, we recommend, instead to replace the complete gearslide.